Mar
23
what’s the best way of stripping wallpaper of a wall without taking the old paint off from underneath it?
By
i want to paint my son’s bedroom walls but it has wallpaper on it, i’ve tried to strip some off but it’s taking chunks of the old paint off underneath and leaving the walls looking uneven. it will leave an uneven finnish. please help!
Related posts:
- How to remove paint from the wall. I have stripped wallpaper off and there is dark brown paint underneath? The problem is a lot of the brown paint has come off in patches leaving white paint underneath. Is there a way I can easily remove the brown paint?...
- When stripping off old wallpaper I found old paint underneath which will only partly come off. Please help? Now we have large areas of clean plaster and even larger areas of plaster covered in old emulsion paint. Some of the paint we have been able to scrape off...
- pros and cons of painting over wallpaper compared to stripping it? How do you strip wallpaper from a wall? We would like to paint our hallway and it currently has silk flower wallpaper on it. Can we just prime it and paint over it or do we have to...
- I need to paint my walls after stripping off wallpaper? the wall is now uneven with some stubborn bits of wallpaper that wont come off, would I need to sand the walls down,?if so how do I do this, am...
- How to strip wallpaper and then paint the walls? Hello… I’ve just stripped the wallpaper off the walls (by using a wallpaper steamer) in my new house, but there’s a few things I think I need to address before...
21 Comments
June 20th, 2010 at 10:00 am
let your son draw on the walls so he can design his room the way he wants!
June 23rd, 2010 at 4:53 pm
Use steam. You could do this with the steam function on a typical clothes iron. There is also a machine that you can get too.
This is time consuming, but it should work.
June 25th, 2010 at 10:48 pm
i’m not sure what it’s called
it’s this steam machine thing
u press it on the wall and it goes steamy and gets rid of the wallpaper!
June 28th, 2010 at 11:46 am
Are you spritzing water on the wallpaper? Leave it for a few minutes and then it should peel off.
July 1st, 2010 at 4:44 pm
How are you stripping it? If you get a spray bottle and fill it with warm water, spray it thoroughly, let that sit maybe five to ten minutes, then peel it off with the assistance of a broad tool like a spackling spatula, it often comes off pretty easily. Afterwards, you should wash down the wall anyway, and then touching up the chips in the paint won’t be that bad.
July 2nd, 2010 at 6:37 am
get a decorative wallpaper striper it is steam powered and is great for getting paper off walls. when you do it don’t leave the steamer on the spot for to long it will go into the plaster and make it bulge and fall off so be careful. the more you use it the better you will be at judging the time to take it away. hope this helps.
July 2nd, 2010 at 12:50 pm
Hire a steam cleaner.
July 3rd, 2010 at 8:51 am
I’ve only stripped wallpaper off once, but there were two layers and unfortunately the walls had not been primed before the wallpaper had been applied so by the time I had the paper off gouges and strips of the drywall had come off.
Are you using a wall paper stripping spray before you strip the paper? Some have also suggested some liquid fabric softener and some water in a spray bottle. I know this works to soften the paper. But I think no matter what you use you are going to have to reconcile yourself to the fact that you are going to lose paint in some areas.
This is easily rectified however once the paper is off and you have cleaned off any remaining adhesive by a coat of primer before you paint the walls. You can even have primer tinted close to your paint color so it will require fewer coats of paint to cover the walls completely.
Good luck.
July 6th, 2010 at 6:00 am
A bucket with hot soapy water and a mop. Soak the walls with the hot water (being sure not to allow any water to drip into electrical sockets) and allow it to soak through the paper (old sheets to soak up excess on floor). When soaked enough even a ruler scraped across should remove it-but be sure not to allow it to dry or you are back to square 1
To fill the uneven patches you’ve created buy some polyfiller (can buy already made in in a tube nowdays) and fill the holes using a filling knife and scratch across the hole to create a smooth finish
I expect it is this tool you have used to scrape the paper off, but if not flat against the wall it does tend to dig inwards and create holes.
July 7th, 2010 at 6:40 am
Use a steamer and a wide scraper. Take off the top layer of the paper carefully so as not to dig in the scraper. Then using warm soapy water take off the backing layer again without digging in the scraper. If you do it this way the emulsion paint underneath will not “melt” with the heat of the steamer and come off in patches. Once you have areas where the paint comes off it is then best to steam the whole wall and take off all of the paint as well.
Be careful with the steamer as if left on the wall too long the plaster is likely to lift and that could fall off in pieces.
Good luck.
July 8th, 2010 at 7:36 pm
put very warm soaps water onto an area a foot square, wipe it over and let it soaked into the paper. a minute or two later you should be able to scrap it of easy
July 10th, 2010 at 10:30 am
I would bet that the walls are drywalled.
What the problem is is that the wall wasn’t prepared properly before wall papering.
Any moister use on the wall seeps in to the drywall which is paper covered & that comes off.
When that happens what is needed is a thin coat of joint cement on the walls to smooth them out. Sad to say this isn’t a task that is easy.
Is the paper just paper or does it have a plastic finish?
if it has a plastic finish you need to break the surface with tiny holes. There is a tool that has little teeth what you run over the walls. This lets the water get to the paper backing.
When I take off wall paper I use a garden sprayer & mist the walls
trying to keep the paper backing of the wallpaper moist but not real wet. Mist the walls & try to keep them moist but not wet. When the paper will roll of easy with just a little washing motion you may be able to save the walls. try a small area keeping it moist but don’t be in a big hurry. Let the water do the work. If you can do it right the drywall won’t get to wet.
All in all this is’t going to be easy. And all because some one tried to say a little time & money when it was first papered.
It isn’t the best thing to do but if you only have a small area to smooth out, & the wall paper is in good shape. You could just patch that area & then prime & paint over the wall paper. Use only
as a last resort to the problem.
Put a cloth or papers down on the floor around the walls to protect the flooring.
July 11th, 2010 at 12:09 pm
washing up liquid added to your water soak the walls all rounds the room then start again to make sure tha they are well soaked you will then find tat you can get hold of a corner and pull the paper off easily if a piece is stubbon soak it again and move on comming back to that piece later
take your time you will find it easier
July 13th, 2010 at 1:46 pm
use a steamer. although it will peel maybe some thin layers of paint will come off. not chunks though
July 14th, 2010 at 12:24 pm
Wet it first and make sure it soaks through it will be easy to get off then. or invest in a steam stripper available in places like b and q
July 16th, 2010 at 5:10 am
i have always used a scorer and a solution of fabric softener and warm water. i score the paper, spray the solution, let it sit for about 15 minutes, spray again, then it almost just peels off, little scraping needed. if the paint still comes off, then you might consider using a sponge painting techique one color 2 or 3 shaded different over the base color. does a pretty good job of concealing defects. i know, i have an house over 100 yrs old, with plaster walls, that were covered with wall paper, partially, i think, to keep the walls in place. i had to fill in more cracks..looked like a road map when i was done, but did some technique painting, and it looks fine..good luck
July 18th, 2010 at 4:42 am
use a steamer but don’t score the paper first that way the wall will not get damp. where it needs filling now you can buy a special filler from big diy stores. if its really bad cover with plaster board, cover with lining paper and paint.
July 19th, 2010 at 5:31 am
You’ll need to spackle where the paint comes off in chunks. If you have textured walls, I believe you can buy a product to repair small patches.
July 20th, 2010 at 1:56 am
steam strip
July 21st, 2010 at 12:14 am
Use a steamer it will take the wallpaper off and leave your walls even.
July 23rd, 2010 at 1:00 pm
what i do its my trade is do as little damage as possible,then give the walls a coat of any matt emulsion,let it dry then mix some artex to a soft paste and skim over bad patches with a plastic calker only a couple of pounds any diy has them,when dry a light rub with sandpaper will leave a flat finish to emulsion over.hope this helps bye